Print Files

GPS Insert

Insert for the GPS module. Small flat bracket with a 6 mm through-hole.

Print18.5 x 6.5 x 3.45 mm. 0.2 mm layer, 20% infill, no supports, PLA.

Personal use only · no resale, no redistribution

AWOK Dual ESP Battery Pack Top

By BlastMaGic

Top cover for the dual-ESP AWOK battery pack, with a cable slot and a D-shaped button port.

Print53 x 37 x 10 mm. 0.2 mm layer, 15% infill, no supports, PLA.

Personal use only · no resale, no redistribution

GPS Antenna Spacer

By BlastMaGic

Round spacer for the GPS antenna, with a hex center pocket.

Print27 x 27 x 14 mm. 0.2 mm layer, 15% infill, no supports, PETG.

Personal use only · no resale, no redistribution

3.5" Halehound case switch mod

By PyroFox

Toggle switch mod for the 3.5 inch case. Needs an SS12F16-G3 switch and two M2x3 mm screws. A STEP file is published on Printables.

Print108.5 x 62.1 x 7.1 mm.

CC BY 4.0 · credit required, commercial use allowed

Holder for board

By Jesse Hale (not OSINTI4L)

Flat plaque, 10 mm thick.

Print215.3 x 214.6 x 10.0 mm.

CC BY-NC-SA 4.0 · credit required, non-commercial, share-alike

Halehound Light Box

By Scorpion

Backlit light box panel of the HaleHound skull. You will need to add your own LEDs.

Print117.8 x 174.7 x 20.0 mm. 0.2 mm layer, 20% infill, PLA, supports on.

CC BY 4.0 · credit required, commercial use allowed